Improvements in or relating to a pressure relief valve gauge for pressure cookers
Реферат: 671,361. Pressure relief valves. NATIONAL PRESSURE COOKER CO. Aug. 24, 1948 [Sept. 27, 1947], No. 22327/48. Class 135. A relief valve for pressure cookers comprises a hollow body member 23 loosely supported on the end of a normally vertical vent pipe 11 by means of a valve member 19 carried inside the body member at its upper end and detent means such as the washer 25 extending inwardly from the body member opposite a portion 13 of the vent pipe of reduced diameter and arranged to permit the body member and the valve member to rock in a pendulous fashion on the vent pipe to relieve excess pressure in the cooker, the centre of gravity of the body member and the valve member being below their point of pivotal' support on the vent pipe. The vent pipe 11 also has an enlarged .head portion 14 and a threaded part 12 adapted to be screwed into the lid of the cooker. The washer 25 is secured in the base of the body member 23 and has inwardly directed projections 26, Fig. 3, the inner surfaces of which are only slightly spaced from the head portion 14 so that unless the body member 23 rises axially, as when it is deliberately removed from the vent pipe, it will be prevented from leaving the vent pipe, even when the cooker lid is turned almost upside down, due to the engagement of the projections 26 with a shoulder 15. One or more ring weights 31 are slidably mounted on the body member 23 and supported by a snap ring in a groove 33. The weights 31 are prevented from sliding off the cap member by a flange 34 on a cap member 35 removably secured on a threaded extension 36 of the valve member 19. Fig. 7 shows a modification in which the retaining washer 46 is of rubber and its projections 47, Fig. 8, are adapted to engage the head portion 14 frictionally so that some effort is required to remove the body member 44 and the valve 41 from the vent pipe. This washer 46 is itself retained by a metal ring 48. The ring weights 52 are kept on the body member 44 by a snap ring 55 which can be depressed into a groove 56. The body member 44 is surmounted by a knob 49 of insulating material. In Fig. 11, the body member 61 has a conical flange 63 to support correspondingly shaped weights 73. These are kept in place by the overhanging edge of a detachable knob 72 of plastic material secured to the valve member 67. Secured in the body member 61 is a retainer sleeve 65 with projections to co-operate with the shoulder 15. In a further modification, the knob 72 is replaced by a wire clip which overhangs the weights 73 and has a circular gripping portion engaging a groove in the valve member 67. Specification 645,945, [Group XVIII], is referred to,.
Improvements in or relating to a pressure relief plug for a pressure cooker or the like
Номер патента: GB663780A. Автор: . Владелец: Ekco Products Co. Дата публикации: 1951-12-27.